/*Copyright 2020-2021 T-Head Semiconductor Co., Ltd.

Licensed under the Apache License, Version 2.0 (the "License");
you may not use this file except in compliance with the License.
You may obtain a copy of the License at

    http://www.apache.org/licenses/LICENSE-2.0

Unless required by applicable law or agreed to in writing, software
distributed under the License is distributed on an "AS IS" BASIS,
WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
See the License for the specific language governing permissions and
limitations under the License.
*/
module px_had_sync(
  clk1,
  clk2,
  rst1_b,
  rst2_b,
  sync_in,
  sync_out
);

// &Ports; @22
input        clk1;         
input        clk2;         
input        rst1_b;       
input        rst2_b;       
input        sync_in;      
output       sync_out;     

// &Regs; @23
reg          sync_ff1_clk1; 
reg          sync_ff2_clk1; 
reg          sync_ff3_clk1; 
reg          sync_ff_clk2; 

// &Wires; @24
wire         clk1;         
wire         clk2;         
wire         rst1_b;       
wire         rst2_b;       
wire         sync_in;      
wire         sync_out;     

  

//==============================================================================
// sync logic from clk2 to clk1
// step 1. flop once in clk2 domain
// step 2. flop twice in clk1 domain
// result: a pulse signal in clk1 domain
// constraint: slow clock --> fast clock
//==============================================================================

always @(posedge clk2 or negedge rst2_b)
begin
  if (!rst2_b)
    sync_ff_clk2 <= 1'b0;
  else
    sync_ff_clk2 <= sync_in;
end

always @(posedge clk1 or negedge rst1_b)
begin
  if (!rst1_b) begin
    sync_ff1_clk1 <= 1'b0;
    sync_ff2_clk1 <= 1'b0;
  end
  else begin
    sync_ff1_clk1 <= sync_ff_clk2;
    sync_ff2_clk1 <= sync_ff1_clk1;
  end   
end

// generates a pulse signal in clk1 domain
always @(posedge clk1 or negedge rst1_b)
begin
  if (!rst1_b)
    sync_ff3_clk1 <= 1'b0;
  else
    sync_ff3_clk1 <= sync_ff2_clk1;
end

assign sync_out = !sync_ff3_clk1 && sync_ff2_clk1;

// &ModuleEnd;  @66
endmodule