30 lines
1.7 KiB
Markdown
30 lines
1.7 KiB
Markdown
|
|
PicoSoC - A simple example SoC using PicoRV32
|
|
=============================================
|
|
|
|
This is a simple PicoRV32 example design that can run code directly from an SPI
|
|
flash chip. This example design uses the Lattice iCE40-HX8K Breakout Board.
|
|
|
|
The flash is mapped to the memory region starting at 0x01000000. The reset
|
|
vector is set to 0x01100000, i.e. at the 1MB offset inside the flash memory.
|
|
|
|
A small scratchpad memory (default 256 words, i.e. 1 kB) is mapped to address
|
|
0x00000000.
|
|
|
|
Run `make test` to run the test bench (and create `testbench.vcd`).
|
|
|
|
Run `make prog` to build the configuration bit-stream and firmware images
|
|
and upload them to a connected iCE40-HX8K Breakout Board.
|
|
|
|
| File | Description |
|
|
| ----------------------------- | --------------------------------------------------------------- |
|
|
| [picosoc.v](picosoc.v) | Top-level PicoSoC Verilog module |
|
|
| [picosoc.v](picosoc.v) | Top-level PicoSoC Verilog module |
|
|
| [spimemio.v](spimemio.v) | Memory controller that interfaces to external SPI flash |
|
|
| [spiflash.v](spiflash.v) | Simulation model of an SPI flash (used by testbench.v) |
|
|
| [testbench.v](testbench.v) | Simple test bench for the design (requires firmware.hex). |
|
|
| [firmware.s](firmware.s) | Assembler source for firmware.hex/firmware.bin. |
|
|
| [hx8kdemo.v](hx8kdemo.v) | FPGA-based example implementation on iCE40-HX8K Breakout Board |
|
|
| [hx8kdemo.pcf](hx8kdemo.pcf) | Pin constraints for implementation on iCE40-HX8K Breakout Board |
|
|
|