7607dacfc4
Fix incorrect register order within stack frame for push/pop
2023-03-20 06:32:20 +00:00
8b73b1b927
Fix mvsa01 r2s decode, Dhrystone runs with Zcb now
2023-03-20 05:03:39 +00:00
c4e0c15160
Fix hookup of uop_atomic signal
2023-03-20 02:40:49 +00:00
3b2ddee06b
Fix push/pop frame format, fix source regnums for mvsa01/mva01s
2023-03-20 02:35:18 +00:00
4aed15540d
Fix destination register for final uop of c.popretz
2023-03-20 01:31:49 +00:00
6b8923a623
Fix bad predecode of a0/a1 in mvsa01/mva01s.
...
Fix bad pop load offset when extra sp adjust is nonzero.
2023-03-20 01:03:49 +00:00
e966e832d2
First attempt at Zcmp
2023-03-20 00:19:23 +00:00
99c0660c3e
Fix decompress of c.sb/c.sh
...
Can now run CoreMark, Hazard3 sw testcases etc using core-v compiler
with Zcb enabled.
2023-03-16 20:36:36 +00:00
59edb2fc5f
Fix predecode of quadrant-00 compressed instruction rs1,
...
to get correct rs1 for new Zbc byte/halfword load/store
2023-03-16 19:10:43 +00:00
78d937e5c8
Yeet Zcb into core
2023-03-16 18:48:15 +00:00
ba3c3138ef
Fix 3 minor Debug Module bugs:
...
- sbdata0 should ignore writes when sbbusyerror or sberror is set
- All sbaddress0 writes and sbdata0 accesses should set
sbbusyerror if sbbusy is set
- sbaddress should not increment if access gets bus error
2023-03-03 13:24:31 +00:00
7101cccf3b
Cut through-path on reset halt request from debug module to bus
2023-01-19 13:47:02 +00:00
52e665fb45
Remove unnecessary clear of sleep flags on bus error (which had a
...
TODO asking if it should be removed) and add some more properties
in its place.
2022-11-05 18:50:41 +00:00
05cb6e7ee8
Rename confusingly named power control signal for allowing clock gate to shut during WFI/block sleep.
2022-11-05 18:26:56 +00:00
c81666177e
Remove FIXME about considering concurrent load/store and debug entry
...
in calculating the privilege of load/stores. This is safe because it
is only the *current* debug mode state which affects load/stores,
and some new properties have been added to ensure load/stores can
not be in aphase at the point debug mode is entered/exited (which
is achieved by delaying the trap). Therefore there is no way for
debug entry to inadvertently boost the privilege of an executing
U-mode load/store.
Also rename a confusingly-named signal for an unsquashable bus
transfer in stage 2 that delays IRQ entry.
2022-11-05 18:19:14 +00:00
97bf2d06f6
Hold off first instruction fetch until pwrup_ack is first seen high
2022-11-05 14:58:47 +00:00
1953773ca5
Don't gate exception into D-mode CSR write, as a valid CSR instruction
...
writing to a valid CSR in D-mode is guaranteed not to raise any exception
(particularly the external data0 CSR is of interest)
2022-10-10 22:15:56 +01:00
ae4ddf7001
Clean up the old/unused W_COUNTER parameter, and use a cleaner tie-off style for the counter CSRs
2022-10-10 16:33:31 +01:00
f771a1294d
Alias DPC to the real program counter, small savings overall
2022-10-10 00:28:42 +01:00
aa438fc37c
Remove op_b (rs2) register from muldiv_seq for modest LUT/FF savings
2022-10-08 18:22:16 +01:00
d3667769d2
Arrange for address buses to be 0 when processor is held in reset
2022-10-08 16:50:58 +01:00
633a07fef9
Tidy up priority tie-offs in irq_ctrl
2022-10-08 16:25:05 +01:00
5e7bf0d604
Don't reset register file by default
2022-10-08 16:24:28 +01:00
489480dc80
Revise default config values, and update docs with new values
2022-10-08 08:43:25 +01:00
874cb20910
Add config headers to tb_cxxrtl instead of using defparams in Makefile
2022-10-08 08:09:26 +01:00
bf1bca2ca5
Remove FPGA synth netlist checked in by mistake
2022-10-06 16:00:27 +01:00
1036d15467
Clean up duplicate declaration of external_irq_pending in hazard3_irq_ctrl
2022-10-06 15:59:54 +01:00
e6aaf4b801
Avoid IRQ to bus through-path when custom IRQs are disabled
2022-10-06 00:16:10 +01:00
c55d3f0d0b
Make custom IRQ and PMP functionality optional. Factor out IRQ controller into separate module.
2022-10-05 23:53:04 +01:00
d1d70efa60
Fix some width issues introduced by last commit
2022-10-05 22:19:02 +01:00
6f8b75c041
Make IRQ vectors right-sized. CXXRTL was spending > 1/3rd of its time in the CSR update.
2022-10-05 22:11:53 +01:00
0915cc2834
Doh
2022-09-08 15:11:24 +01:00
9eb8590858
Add generate to avoid elaborating internals of PMP/triggers with 0 PMP regions or triggers.
2022-09-05 00:36:41 +01:00
18c64bd633
Add no_rw_check attribute to regfile memory to avoid recent Yosys area regression
2022-09-04 23:56:14 +01:00
787a7ec372
Fix bad preprocessor conditional in ECP5 JTAG DTM
2022-09-04 23:48:58 +01:00
c594ec42e9
Change style of IRQ register tie-offs as Yosys was not able to trim them for iCE40 synthesis.
2022-09-04 23:43:24 +01:00
624d39669d
Fix up new asserts in hazard3_power_ctrl. Add power signals to formal TBs.
2022-08-29 19:20:09 +01:00
1c2249dbef
Typo
2022-08-29 16:25:12 +01:00
6abd93eb49
Oops, masked the wakeup-on-halt request path when I masked IRQs on WFI state.
2022-08-29 16:15:19 +01:00
099f0467fb
Clean up remnants of the 'wfi_is_nop' thing that seemed like a good idea at the time
2022-08-29 15:56:57 +01:00
954bae5cf1
Implement block/unblock instructions, and fix questionable partial masking of sleep signals on exceptions. Add simple test for self-block/unblock with loopback in tb.
2022-08-29 14:52:01 +01:00
2ae2463b97
First stab at adding wake/sleep state machine
2022-08-28 19:50:04 +01:00
bf38d93d33
Remove references to AHB-Lite, describe buses as (a subset of) AHB5
2022-08-28 14:15:20 +01:00
9a60f06c43
Fix trigger enable condition
2022-08-23 01:05:46 +01:00
fef6d80fd4
tcontrol.mpte is not supposed to change on trap exit, unlike mstatus.mpie
2022-08-23 00:19:56 +01:00
9e11c0e5a8
Fix tdata1.dmode being writable from M-mode
2022-08-23 00:08:17 +01:00
04f138ae0e
Fix mcontrol.execute not being writable. Enable hardware breakpoint debug tests: Hwpb1/2, JumpHBreak, TriggerExecuteInstant
2022-08-23 00:05:30 +01:00
49c2edeff8
Avoid reserved keyword
2022-08-22 10:26:20 +01:00
53902a901b
Fix bad rdata width for tdata1 (which also caused the trigger type to appear as legacy SiFive, oops)
2022-08-22 09:47:19 +01:00
b90d12efed
CSRs: avoid use of wdata_update in rdata for meicontext, which the SMT2 backend sees as a loop.
...
There is no functional loop here since this is an acyclic path between different bits of the rdata vector, but it makes sense that this would confuse tools that don't bitblast all the vectors.
2022-08-22 09:18:57 +01:00
Luke Wren